1
Warning
Precautions
Power requirements
requirements for electrical equipment differ from area to area.
operating voltage of this machine is preset at the factory according
to It's intended destination. However. some models are equipped with a
voltage selector. If your machine is so equipped. before connecting,
check to see that the VOLTAGE SELECTOR on the bottom panel is set
to the
for your area.
it correctly before
in the power cord.
220
for Europe except the UK.
for UK and Australia.
If the VOLTAGE SELECTOR is not set for your
area:
Confirm that the power cord is
Move the VOLTAGE SELECTOR with
a screwdriver so that the marker is
above
for your area.
What you should know to protect yourself and
the Akai MX73.
.
l
l
Only
a
professional repair or reassemble the Akai MX73.
An
might touch the internal parts and receive a
l
a child to put anything, especially metal, into the Akai
MX73.
too.
l
Use
a
AC power source. Never use
a DC power
l
water is
on the Akai MX73. disconnect it and call your
l
sure that
MX73 is well ventilated and away from direct
l
To
l
vofd
to the internal circuits and the external surface,
etc.).
l
Avoid using spray type insecticide near the Akai MX73. It can
and might ignite suddenly.
l
To avoid damaging the finish, never use denaturated alcohol, paint
chemicals to
the Akai MX73.
l
the Akal MX73 on the
and
surface.
TO enjoy the
MX73 for a long time, please read this operator's
a
write down the model and serial numbers and
regarding warranty coverage as welt as a
of the
Then, contact your nearest
Akai
or the Service Department of Akai Electric Company,
FOR CUSTOMERS
IN THE UK
FOR YOUR
The flex supplied with your machine will have
as shown in the
illustration.
TWO CORE FLEX
IMPORTANT
The
in this mains
are cotoured in
with the
Blue: Neutral
As the
of the wires
the mains
of
may not correspond with the
cotoured markings identifying the terminals in
your
proceed as Mows: The wire
is coloured blue must be connected to the
terminal which is marked with the letter N or
cofouredbtack.
The wire which is coloured brown must be
connected to the terminal which is marked
l
Do not connect any wire to the larger ptn marked E or
whe
wiring a
Enaure that all terminals am
that no
strands of
exist.
CAUTION: TO
THE RISK
ELECTRIC
DO
REMOVE COVER
BACK).
NO
PARTS INSIDE.
SERVICING TO
PERSONNEL.
