English
|
3
Installation Procedure
Installation Procedure
1.To prevent a short circuit, remove the key from
the ignition and disconnect the
- battery.
2.Make the proper input and output wire
connections for each unit.
3.Connect the wiring harness wires in the following
order: ground, ignition, reverse and camera unit.
4.Connect the wiring harness connector to the
video box unit.
5.Install the unit in your car.
6.Reconnect the
- battery.
2WARNING
· If you connect the ignition wire (Red) to the car chassis
(Ground), you may cause a short circuit, that in turn may
start a fire. Always connect those wires to the power
source running through the fuse box.
· Do not cut out the fuse from the ignition wire (Red). The
power supply must be connected to the wires via the
fuse.
2CAUTION
· If your car's ignition does not have an ACC position,
connect the ignition wires to a power source that can be
turned on and off with the ignition key. If you connect the
ignition wire to a power source with a constant voltage
supply, as with battery wires, the battery may die.
· If the fuse blows, first make sure the wires aren't touching
to cause a short circuit, then replace the old fuse with one
with the same rating.
· Insulate unconnected wires with vinyl tape or other
similar material. To prevent a short circuit, do not remove
the caps on the ends of the unconnected wires or the
terminals.
· After the unit is installed, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.
· Install so that it does not obstruct the rear field of view.
· Install so that it does not protrude from the side of the
car.
· Do not perform installation in rain or fog.
· When humidity is high, dry the surface to which the unit
is to be attached before installing.
· Moisture on the attachment surface reduces adhesive
strength, which may lead to the unit coming off.
· Do not attach the camera bracket to areas on the car
body treated with fluorocarbon resin, or glass.
· May result in the rear view camera falling off.
- Do not apply water to the unit.
- Do not expose the unit to rain.
- Do not subject the camera to unnecessary force.
- Thoroughly clean where tape is used for sticking on
the unit.
· Refer to the Instruction's manual for details on connecting
the other units, then make connections correctly.
· Secure the wiring with cable clamps or adhesive tape.
To protect the wiring, wrap adhesive tape around them
where they lie against metal parts.
· Route and secure all wiring so it cannot touch any
moving parts, such as the gear shift, handbrake and seat
rails.
· Do not route wiring in places that get hot, such as near
the heater outlet. If the insulation of the wiring melts or
gets torn, there is a danger of the wiring short-circuiting
to the vehicle body.
· When replacing the fuse, be sure to use only fuse of the
rating prescribed on the fuse holder.
· To minimize noise locate the TV antenna cable, radio
antenna cable and RCA cable as far away from each other
as possible.
· Do not install the video box unit in places where it may
become subject to high temperatures or humidity, such
as:
- Places close to a heater, vent or air conditioner.
- Places exposed to direct sunlight, such as on top of the
dashboard or the rear shelf.
- Places that may be splashed by rain, for example close
to the door.
