4
DNX series DNX7360BT/ DNX7360BTM
Before Use
2WARNING
To prevent injury or fire, take the
following precautions:
· To prevent a short circuit, never put or leave
any metallic objects (such as coins or metal
tools) inside the unit.
· Do not watch or fix your eyes on the
unit's display when you are driving for any
extended period.
How to reset your unit
· If the unit or the connected unit fails to
operate properly, press the Reset button.
The unit returns to factory settings when
the Reset button is pressed.
· Remove the USB device before pressing
the Reset button. Pressing the Reset button
with the USB device installed can damage
the data contained in the USB device. For
how to remove the USB device, see <How
to play media> (page 16).
· When the unit is turned on after pressing
the Reset button, the Initial SETUP screen is
displayed. Refer to <Initial Setup> (page 100).
Reset button
Cleaning the Unit
If the faceplate of this unit is stained, wipe it
with a dry soft cloth such as a silicon cloth.
If the faceplate is stained badly, wipe the
stain off with a cloth moistened with neutral
cleaner, then wipe it again with a clean soft
dry cloth.
¤
· Applying spray cleaner directly to the unit may
affect its mechanical parts. Wiping the faceplate
with a hard cloth or using a volatile liquid such
as thinner or alcohol may scratch the surface or
erases characters.
About the Terminals of the Unit and
Faceplate
· To prevent deterioration, do not touch the
terminals of the unit and faceplate with
your fingers.
· If the terminals on the unit or faceplate get
dirty, wipe them with a clean soft dry cloth.
Lens Fogging
When you turn on the car heater in cold
weather, dew or condensation may form
on the lens in the disc player of the unit.
Called lens fogging, this condensation on
the lens may not allow discs to play. In such
a situation, remove the disc and wait for
the condensation to evaporate. If the unit
still does not operate normally after a while,
consult your Kenwood dealer.
Handling discs
· Do not touch the recording surface of the
disc.
· Do not stick tape etc. on the disc, or use a
disc with tape stuck on it.
· Do not use disc type accessories.
· Clean from the center of the disc and move
outward.
· When removing discs from this unit, pull
them out horizontally.
· If the disc center hole or outside rim has
burrs, use the disc only after removing the
burrs with a ballpoint pen etc.