For the
U.S.A.
FCC
WARNING
This equipment may generate or use radio frequency energy. Changes or modifica equipment
may cause harmful interference unless the modifications are expressly approved in the instruction
manual. The user could lose the authority to operate this equipment if an unauthorizedchange or
modification is made.
NOTE:
This equipment has been tested
and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment may cause harmful
interference to radio communications,
if it is not installed and used in accordance with the
instructions. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- - Reorient or relocate the receiving antenna.
-
- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
-- Consult the dealer or an experienced
technician for help.
connected.
For CANADA
Canadian
Compliance Notice
This Class B digital apparatus meets all requirements of the Canadian
Caussig Equipment Regulations.
For the
U.S.A.
CAUTION:
Use of controls or adjustments or performance
of proceduresother than those specified herein
may result in hazardous radiation exposure.
In compliance with Federal Regulations, fol-
lowing are reproductions of labels on, or inside
the product relating to laser product safety.
KENWOOD CORPORATION
2967-3,
ISHIKAWA-CHO,
HACHIOJI-SHI,
TOKYO, JAPAN
