PORTABLE CD PLAYER
INSTRUCTION MANUAL
Unpacking
Unpack the unit carefully and make sure that all the accessories are
present.
If any accessories are missing, or if the unit is damaged or fails to oper-
ate, notify your dealer immediately. If the unit was shipped to you di-
rectly, notify your shipper immediately. Kenwood recommends that you
retain the original carton and packing materials in case you need to move
or ship the unit in the future.
Keep this manual handy for future reference.
B60-5307-08 00 (M) AP 0204
For your records
Record the serial number, found on the back of the unit, in the
spaces designated on the warranty card, and in the space pro-
vided below. Refer to the model and serial numbers when-
ever you call upon your dealer for information or service on
this product.
Model
Serial Number
Specifications
Format
System ................................................................ Compact disc digital audio system
Laser ......................................................................................... Semiconductor laser
Audio
Frequency response ............................................................ 20 Hz to 20 kHz,
± 3 dB
PHONES output level (32
, 1 kHz ) .................................................. 3 mW + 3 mW
Line output/impedance
Bass Boost ON : ........................................................................... 0.83 Vrms/1 k
Bass Boost OFF : .......................................................................... 0.31 Vrms/1 k
Power supply
Commercially-available alkaline batteries (R03/AAA) x 2 ............................... DC 3 V
Battery life (From fully-charged condition)
÷ At 0.1 mW + 0.1 mW power (32 load)
÷ Typical values in recharging/continuous operation at an ambient temperature of 20oC.
÷ The values are variable depending on the battery manufacturer, battery type, operating
environment and temperature.
Dimensions (W x H x D) .................. 150 mm x 22.7 mm x 130 mm (5- 7/8" x 7/8" x 5-1/8")
Weight (net) ........................................................................................................ 176 g (6.2 oz)
Note:
KENWOOD follows a policy of continuous advancements in development. For this reason specifications may
be changed without notice.
Maintenance
Simple care
Care of lens
When the lens in the pick-up gets dirty, malfunctions including
the impossibility of playback may occur. The lens should be
cleaned using a commercially available camera lens blower, etc.
Do not touch the lens to prevent damaging the mechanism.
Also do not use a lens cleaner or disc cleaner product.
Care of main unit
When the unit gets dirty, clean with a soft, dry cloth. If the unit
is stained seriously, a moistened cloth can be used. Do not use
benzine or thinner for these will damage the unit.
Cleaning the plug
Wipe the headphone plug with a soft cloth to keep it clean.
A dirty plug may cause noise or malfunction.
Caution on disc used
Usable discs
This unit is capable of playing back the Audio CD discs, CD-R/CD-RW (CD-DA) discs and
discs carrying the
marking. Other discs cannot be played.
8 cm single CDs can be played as they are; do not use a commercially-available single CD
adapter.
Handling
Hold compact discs so that you do not touch the playing surface.
Do not attach paper or tape to either the playing side or the label side of compact discs.
Never play a cracked or warped disc.
During playback, the disc rotates at high speed in the player. Therefore, to avoid danger,
never use a cracked or deformed disc or a disc repaired with tape or adhesive agent.
Cleaning
If fingerprints or foreign matter become attached
to the disc, lightly wipe the disc with a soft cotton
cloth (or similar) from the center of the disc out-
wards in a radial manner.
Storage
When a disc is not to be played for a long period of time, remove it from the CD player and
store it in its case.
Precaution against condensation
Immediately after a room is heated or in a room with high humidity (or vapor), the unit may
malfunction due to the condensation of dew or mist on the pick-up lens. In such a case,
leave the unit for about an hour before trying to use it again.
Accessories
Headphones (1), Remote control (1)
Safety precautions
Caution : Read this page carefully to ensure safe operation.
WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT SAFEGUARDS
Please read all of the safety and operating instructions before operating this appliance. Adhere to all warnings on the appliance and in the instruction manual.
Follow all the safety and operating instructions. These safety and operating instructions should be retained for future reference.
Part names
Sound skip guard function (D.A.S.C.)
D.A.S.C. (Digital Anti Shock Circuit)
When the D.A.S.C. function is operating, about a 10 [Max. 12-seconds
(Approx.)] or 40 seconds [Max. 48-seconds (Approx.)] portion of signals is
always stored in memory. Consequently, when the unit receives an im-
pact, playback will continue without interruption even if the signal from
the light pickup is interrupted.
"Wide CAPTURE" uses a method strong in regard to vibrations in the ro-
tation direction in addition to the conventional D.A.S.C. function, so that
the sound skip guard function is made even stronger.
In case of difficulty
What seems to be a serious trouble may sometimes be due to a simple mistake. Before
calling for service, check the items shown in the following table again. (If you request servic-
ing due to the reasons shown in the table, the service may be charged in some cases.)
÷ The HOLD switch is set to ON.
÷ The batteries are exhausted.
÷ The disc is placed upside down.
÷ Condensation has occurred in-
side the unit.
÷ The headphones are connected
incompletely.
÷ The headphones are connected
to LINE OUT jack
÷ The volume is set to the
minimum position on the unit
or remote control unit.
÷ A strong vibration that exceeds
the capacity of the D.A.S.C. has
occurred.
÷ The disc is dirty.
÷ The lens is dirty.
÷ The headphone plug is dirty.
÷ The batteries are low.
÷ The headphone plug is dirty.
÷ The batteries are low.
÷ The headphones are connected
incompletely.
÷ A source of strong magnetism
or radio wave, such as a TV set
or cellular phone, is present
near the unit.
÷ Set the switch to OFF.
÷ Replace the two alkaline batter-
ies.
÷ Place the disc with the labeled
side up.
÷ Leave the unit for about 1 hour
before re-use.
÷ Insert the plug securely into the
PHONES jack.
÷ Insert the plug securely into the
PHONES jack.
÷ Adjust the volume on the unit or
remote control unit..
÷ Place the unit in a place not sub-
ject to vibration.
÷ Clean it.
÷ The lens should be cleaned us-
ing a commercially available cam-
era lens blower
÷ Clean it.
÷ Replace the batteries.
÷ Clean it.
÷ Replace the batteries.
÷ Insert the plug securely into the
PHONES jack.
÷ Install the unit away from a TV
set, cellular phone, etc.
Symptom
Cause
Remedy
Note :
1. This system uses a microcomputer so it may malfunction due to external noise or interference.
In such a case, remove the batteries, insert the batteries again.
2. Erroneous operation may occur when the headphone plug is plugged or unplugged; but this is
not a malfunction.
Pressing a key
cannot initiate an
operation or turn the
unit on.
No sound is heard
from the head-
phones.
Sound skips, or is
interrupted.
Noise interferes.
÷ The reproduced sound is interrupted during switching.
Notes
Notes
Notes
DPC-X527 (EN-M)
The marking this product has been classified as Class 1. It means
that there is no danger of hazardous radiation outside the product.
Location: Back panel
CLASS 1
LASER PRODUCT
The marking of products using lasers (For countries other than U.S.A.,
U.S.-Military and Canada)
Notes
÷ Always ensure that the headphone plug is fully inserted before turning
the power ON.
÷ If the headphone plug is inserted or removed while playback is in progress,
the liquid crystal display may be inconsistent with the operation status of the
unit. To correct this, turn the power OFF and then ON again.
÷ When the remote control plug is connected, the remote control operation
keys may not operate. To correct this, pull the remote control's plug out of
the unit, wait about 5 seconds, and then re-insert it.
DPC-X527
Unit
Display
Remote control
Mechanism of D.A.S.C.
Storage of
digital data
Digital memory
Reproduced sound
÷ Depending on the extent of the impact, the data in the memory may be used
up, so the playback skip protection may momentarily be ineffective.
÷ When the D.A.S.C. function is activated, the disc may stop or start to rotate.
Setting the D.A.S.C.
Note
Note
D.A.S.C. H position : 40 sec. [Max. 48-seconds (Approx.)] memory
Data are held for about 40 sec. [Max. 48-seconds (Approx.)]
D.A.S.C. L position : 10 sec. [Max. 12-seconds (Approx.)] memory
Data are held for about 10 sec. [Max. 12-seconds (Approx.)]
There is no data compression, so that listening with high sound
quality is possible.
Å VOL. + - keys
i Display
Ç OPEN switch (Use to open top cover)
Î D.A.S.C. switch
HOLD switch
Ï B.BOOST (Bass boost) key
Ì REPEAT/P.MODE
(Repeat play/Program mode) key
Ó
7 (Stop/Off) key
¬
6 (Play/pause) key
Ô
4, ¢ (Skip/Search) keys
PHONES (Phones/Remote control) jack
Ò LINE OUT jack
Slide the D.A.S.C. switch to select the desired setting.
Ç
i
Ò
Å
È
Ó
Ì
Ï
Î
Ô
(Front)
(Side)
D
Bass boost indicator
Repeat mode
indicator
Program mode indicator
Battery duration indicator
Track number display
Playng time display
7 (Stop/Off) key
4, ¢ (Skip/Search) keys
PHONES jack
6 (Play/pause) key
HOLD switch
VOL. + - keys
The keys with the same names as those on the main unit have the same
functions as the main unit keys.
D.A.S.C. L
D.A.S.C. H
Approx. 8 Hours
Approx. 14 Hours
Commercially-available
alkaline batteries
(R03/AAA)
1. Power sources -- The unit should be connected to a power supply only of the type de-
scribed in the operating instructions or as marked on the appliance.
2. Power-cord protection -- Power-supply cords should be routed so that they are not likely
to be walked on or pinched by items placed upon or against them. Pay particular attention to
cords at plugs, convenience receptacles, and the point where they exit from the unit.
3. Enclosure removal -- Never remove the enclosure. If the internal parts are touched acci-
dentally, a serious electric shock might occur.
4. Drop -- Do not drop the unit or apply strong shock to it. (Damage due to dropping the unit is
not covered by the warranty.)
5. Ventilation -- Avoid hindering the ventilation of the unit by covering it with a cloth, etc.
6. Abnormal smell -- If an abnormal smell or smoke is detected, immediately turn the power
OFF and pull out the power cord. Contact your dealer or nearest service center.
7. Heat -- Avoid placing the unit under direct sunlight or near a source of heat such as heating
equipment. Particularly, never leave it in an automobile or on the dashboard.
8. Temperature -- The unit may not function properly if used at extremely low, or freezing
temperatures. The ideal ambient temperature is above +5°C (41°F).
9. Water and moisture -- The appliance shall not be exposed to dripping and splashing -- for
example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a
swimming pool, etc.
10. Dust and moisture -- Avoid places where is dusty or where the humidity is high.
11. Vibrations -- Avoid placing the unit on an unstable place such as a shelf or in a place
subject to vibrations.
12. Magnetic fields -- Keep the unit away from sources of magnetic fields such as TV sets,
speaker systems, radios, motorized toys or magnetized objects.
13. Cleaning -- Do not use volatile solvents such as alcohol, paint thinner, gasoline, or ben-
zine, etc. to clean the cabinet. Use a clean dry cloth.
14. Nonuse periods -- The power cord of the unit should be unplugged from the outlet when
left unused for a long period of time.
15. Damage requiring service -- The unit should be serviced by qualified service personnel
when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the unit.
C. The unit has been exposed to rain.
D. The unit does not appear to operate normally or exhibits a marked change in performance.
E. The unit has been dropped, or the enclosure damaged.
16. Servicing -- The user should not attempt to service the unit beyond that described in the
operating instructions. All other servicing should be referred to qualified service personnel.
17. CAUTION -- TO PREVENT ELECTRIC SHOCK DO NOT USE THE AC PLUG WITH AN
EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE
FULLY INSERTED TO PREVENT BLADE EXPOSURE.
