DV-505/DVF-4050/-S
2
CONTENTS / ACCESSORIES / CAUTIONS
CONTENTS / ACCESSORIES / CAUTIONS ............. 2
DISASSEMBLY FOR REPAIR....................................3
BLOCK DIAGRAM ......................................................4
WIRING DIAGRAM .....................................................5
PC BOARD..............................................................10
SCHEMATIC DIAGRAM...........................................14
EXPLODED VIEW....................................................21
PARTS LIST.............................................................23
SPECIFICATIONS......................................Back cover
Contents
Cord RCA 1p
(E30-7235-08)
Cord RCA 3p
(E30-2990-08)
Remote control unit (1)
(A70-1570-08)
Batteries (R03/AAA) (2)
*AC plug adaptor (1)
(E03-0115-05)
* Use to adapt the plug on the
power cord to the shape of the
wall outlet.
(Accessory only for regions
where use is necessary.)
Note related to transportation and movement
Before transporting or moving this unit, carry out the follow-
ing operations.
1. Set the POWER key to ON without loading a disc.
2. Wait a few seconds and verify that the display shown
appears.
3. Set the POWER key to OFF.
Beware of condensation
When the difference between the internal temperature of the unit
and external atmosphere is large, dew (mist) may be produced on
the internal parts of the unit. In such a case, turn the unit ON and
leave it for a few hours until the condensation has dried up.
Be especially careful in the following conditions:
When the unit is brought into a place where there is a large differ-
ence in temperature between the previous location, when the
humidity of the listening room is high, etc.
The marking is located on the rear panel and says that
the component uses laser beams that have been clas-
sified as Class 1. It means that the unit is utilizing laser
beams that are of a weaker class. There is no danger of
hazardous radiation outside the unit.
CLASS 1
LASER PRODUCT
The marking of products using lasers
(Except for some areas)
Operation to reset
The microprocessor may fall into malfunction (impossibility to oper-
ate erroneous display, etc.) when the power cord is unplugged while
power is ON or due to an external factor. In this case, execute the
following procedure to reset the microprocessor and return it to
normal condition.
÷Please note that resetting the microprocessor clears the
contents stored in, it returns the microprocessor to the condi-
tion when it left the factory.
1In POWER ON condition, keep the DISC 3 key and the 4
4
4
4
4
(Skip) key pressed at the same time.
2When both keys are pressed, the region code of the unit, the
software version, etc. will be displayed on the display. (When
nothing is done, the display of this information continues.)
Example: 71 . 16 . 06:14
3Press the DISC 4 key and the 4
4
4
4
4 key at the same time.
"BYE" will be shown on the display.
4Press the ON/OFF key to go to Power OFF.
5When Power ON is performed with the ON/OFF key, the
settings become the default factory settings.
Cautions
Accessories
Attention
Please contact our KENWOOD Service Department in your
side if you want the service information; Circuit Description.
Full Described Parts list and so. Information is available to
you by internet from us.
