Digital Cable (Optical) ...(1)
(E35-3626-08)
Remote control unit ..........(1)
(A70-1645-08)
Video cord (Yellow) .........(1)
(E30-7311-08)
Audio cord (White / Red) ...(1)
(E30-7310-08)
Batteries (R03/"AAA" -size) ...(2)
DVF-S500
2
ACCESSORIES / CAUTIONS
Accessories
Cautions
"DTS" and "DTS Digital Out" are trademarks of
Digital Theater Systems, Inc.
Manufactured under license from Dolby Laboratories.
"Dolby" and the double-D symbol are trademarks of Dolby
Laboratories.
This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property rights. Use of this copyright
protection technology must be authorized by Macrovision, and is intended for home and other limited viewing uses only unless otherwise authorized
by Macrovision. Reverse engineering or disassembly is prohibited.
Consumers should note that not all high definition television sets are fully compatible with this product and may cause artifacts to be displayed in the
picture. In case of 525 progressive scan picture problems, it is recommended that the user switch the connection to the "STANDARD DEFINITION"
output. If there are questions regarding our TV set compatibility with this model 525p DVD player, please contact our customer service center.
Caution on condensation
Before transporting or moving this unit, carry out
the following operations.
1. Set the
(POWER) key to the ON without loading a disc.
2. Wait a few seconds and verify that the display shown appears.
3. Set the
(POWER) key to OFF.
Note related to transportation and movement
Condensation (of dew) may occur inside the unit when there is a great differ-
ence in temperature between this unit and the outside. This unit may not fun-
ction properly if condensation occurs. In this case, leave the unit for a few
hours and restart the operation after the condensation has dried up.
Be specially cautious against condensation in the following circumstances:
When this unit is carried from one place to another across a large difference
in temperature, when the humidity in the room where this unit is installed inc-
reases, etc.
CHAP
TRACK
HOUR
MIN
TITLE
Operation to reset
The microprocessor may fall into malfunction (impossibility to operate
erroneous display, etc.) when the power cord is unplugged while
power is ON or due to an external factor.
In this case, switch off the power, wait for several seconds, and then
switch the power on again.
Return to the factory defaults by resetting the microprocessor is done
as shown as follows.
Unplugg the power cord after turn the
(POWER) key OFF.
Then, while holding down the
(POWER) key, plug the power cord.
Please note that resetting the microcomputer will clear the contents
of the memory and returns the unit to the state it was in when it left
the factory.
CAUTION
Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
In compliance with Federal Regulations, the following are reproductions of labels on, or inside the product relating to laser product safety.
KENWOOD CORP. CERTIFIES THIS EQUIPMENT
CONFORMS TO DHHS REGULATIONS NO. 21 CFR
1040.10, CHAPTER 1, SUBCHAPTER J.
Location: Back Panel
KENWOOD CORPORATION
2967-3, ISHIKAWA-CHO,
HACHIOJI-SHI,
TOKYO, JAPAN
For the U.S.A.
