-- 3 --
CD MD AUTO CHANGER CONTROLLER
REP
RDM
3
-
+
4¢
PWR
M.RDM
D.REP
TRACK
D I S C
8
/
D.SCN
MHz
DISC
TRACK
FREQ
LEVEL
Reset button
Take the following precautions to
prevent fire and avoid personal injury:
· When extending the ignition wire, battery
wire, or ground wire, use 0.75mm2 (AWG18)
or larger automotive grade wire to avoid wire
deterioration or damage to the covering.
· Check that no metal objects (coins, tools,
etc.) are left inside the unit to avoid short
circuits.
· If you smell or see smoke, turn the power off
immediately and consult your Kenwood
dealer.
· Do not touch the liquid crystal fluid if the LCD
is damaged or broken due to shock. The
liquid crystal fluid may be dangerous to your
health or even fatal.
If the liquid crystal fluid from the LCD
contacts your body or clothing, wash it off
with soap immediately.
Take the following precautions to
keep the unit in proper working order.
· Be sure the unit is connected to a 12V DC
power supply with a negative ground
connection.
· Do not open the top or bottom cover.
· Do not install the unit in places it is exposed
to direct sunlight, high heat or humidity,
water may splash over it, or dust exists.
2CAUTION
2WARNING
· When replacing a fuse, only use a new one
with the prescribed rating. Using a fuse with
the wrong rating may cause your unit to
malfunction. on hot places such as above the
dashboard.
· To prevent a short circuit when replacing a
fuse, first disconnect the wiring harness.
· If you have difficulty in installing this unit in
your vehicle, contact your Kenwood dealer.
· If it doesn't seem to be working properly,
first press the Reset button. If the
malfunction persists, consult your Kenwood
dealer.
· Some car stereos cause the sound of the
tuner to make for a moment when an
engine is activated.
· The reception of the tuner may be reduced
a little if the KCA-R42FM is used.
· If the sound is lower than the tuner sound,
raise up the volume level of the CD/MD
with using the receiver.
· Do not use your own screws. Use only the
screws provided. If you use the wrong
screws, you could damage the unit.
NOTE
O-N selection switch
When the disc changer with the O-N
selection switch is connected, set the switch
to "O" position to operate the disc changer
mode.
Cleaning the Unit
If the front panel gets dirty, turn off the
power and wipe the panel with a dry silicon
cloth or soft cloth.
Do not use hard cloths or paint thinner,
alcohol, or other volatile solvents. These may
damage external surfaces or remove
indicator characters.
FCC WARNING
This equipment may generate or use radio
frequency energy. Changes or modifications
to this equipment may cause harmful
interference unless the modifications are
expressly approved in the instruction manual.
The user could lose the authority to operate
this equipment if an unauthorized change or
modification is made.
This Class B digital apparatus complies with
Canadian ICES-003.
NOTE
2CAUTION
Safety Precautions
KCA-R42FM_U.S(K/En)
02.12.16
9:13 AM
Page 3