KRK-11
HANDHELD CONTROL HEAD INTERFACE KIT
INSTRUCTION MANUAL
© B62-2102-00 (M)
Features
This is an optional accessory for the KCH-16.
You can connect an external speaker to the interface box.
supplied accessories
Item
Part Number
Quantity
Interface Box
-
1
Main body panel assembly
-
1
Ground cable
E30-3085-XX
1
Retaining band
J61-0307-XX
1
Retaining bracket
J21-4354-XX
2
Connector
E59-0426-XX
1
Screw set
N99-2069-XX
1
Screw set
N99-2070-XX
1
Instruction manual
B62-2102-XX
1
Main body panel assembly
Screw set : N99-2069-XX
(For Interface box)
Interface box
Ground cable
Retaining band
Retaining bracket
Screw set N99-2070-XX
(For Main body panel assembly)
Connector
Note:
The following instructions are for use by your Kenwood dealer, an
authorized Kenwood service facility, or the factory.
Refer to the Service manual for detailed information regarding the
installation of the KCH-16.
installation
The following tools and parts are required for installing the handheld
control head interface kit.
Phillips No. 2 screw driver
KCT-22 Remote Control Cable
Transceiver
External speaker
(Option)
KCT-22 (Option)
Remote Control
Cable
Interface box
KCH-16
hanger
Note:
When connecting the KCH-16 to the Interface box, do not connect
the MIC to the programming connector of the Interface box.
The programming connector of the interface box is dedicated to
programming.
The control connector of the interface box is dedicated to the
KCH-16; do not use this connector for other equipment.
The optional jack is supplied for future expansion. It cannot be used
at this time.
Do not remove the covers or caps of connectors that are not
currently being used.
After connecting the KCH-16 and turning on the power, do not
remove the KCH-16.
KCT-18 (Option)
Ignition Sense Cable
