FM indoor antenna (1)
(T90-0861-08)
AM loop antenna (1)
(T90-0846-08)
Remote control unit (1)
(A70-1568-05): E,T,H type
(A70-1569-05): K,X type
Batteries(R6/AA) (2)
RXD-M35
2
CONTENTS / ACCESSORIES / CAUTIONS
CONTENTS / ACCESSORIES / CAUTIONS ............. 2
EXTERNAL VIEW .......................................................3
CIRCUIT DESCRIPTION ............................................4
ADJUSTMENT ..........................................................14
PC BOARD .............................................................. 15
SCHEMATIC DIAGRAM .......................................... 19
EXPLODED VIEW ....................................................25
PARTS LIST..............................................................26
SPECIFICATIONS ......................................Back cover
Contents
Accessories
Cautions
Operation to reset
The microcomputer may fall into malfunction (impossibil-
ity to operate, erroneous display, etc.) when the power
cord is unplugged while unit is ON or due to an external
factor. In this case, execute the following procedure to
reset the microcomputer and return it to normal condi-
tion.
Unplug the power cord from the power outlet, then while
holding the POWER or
key depressed, plug the power
cord again.
Please note that resetting the microcomputer clears
the contents stored in and it returns to condition
when it left the factory.
or
After resetting the microcomputer, the display will show
as follow:
standby/ timer
POWER
standby/ timer
The marking of products using lasers (For countries other than U.S.A., U.S.-Military and Canada)
The marking of this product has been classified as Class 1. It means
that there is no danger of hazardous radiation outside the product.
Location: Back panel
CLASS 1
LASER PRODUCT
CAUTION
VISIBLE LASER RADIATION
WHEN OPEN. DO NOT STARE
INTO BEAM OR VIEW DIRECTLY
WITH OPTICAL INSTRUMENTS.
Inside this laser product, a laser diode classified as Class 3A laser
radiation is contained as alerted by the internal caution label shown
above. Do not stare into beam or view directly with optical instruments.
1 Remove the CD from the unit.
2 Press the CD 6 key.
3 Wait for some time and verify that the display
appears as above.
4 Wait a few seconds and turn the unit OFF.
Note related to transportation and movement
Before transporting or moving this unit, carry out the follow-
ing operations.
