Remote control unit (1)
RC-R0629(A70-1658-05)
AM loop antenna (1)
(T90-0893-05)
FM indoor antenna (1)
(T90-0905-05)
Batteries (R6/AA) (2)
VRS-6100
2
Resetting the Microcomputer
The microcomputer may malfunction (unit cannot be operated, or
shows an erroneous display) if the power cord is unplugged while
the power is ON, or due to some other external factor. If this
happens, execute the following procedure to reset the microcom-
puter and return the unit to its normal operating condition.
Unplug the power cord from the wal l outlet, then plug it back in
while holding down the PO WER ON/STANDBY
key.
Please note that resetting the microcomputer will clear the contents
of the memory and returns the unit to the state it was in when it left
the factory.
Memory back-up function
If the power supply to the receiver is shut down for about a day
or more, the following settings will be reset to the initial condi-
tions. Please be careful.
Power mode = OFF
Volume level = - 66 dB
Dimmer level = OFF (Brightest condition)
Broadcast band = FM
Frequency setting = 87.50 MHz
Tuning mode = AUTO
Listen mode setting = STEREO
Input selector settings = TUNER
TONE ON/OFF = OFF
LOUDNESS ON/OFF = OFF
BASS BOOST ON/OFF = OFF
CONTENTS / ACCESSORIES / CAUTIONS
ACCESSORIES
CONTENTS
CONTENTS / ACCESSORIES / CAUTIONS ...............2
PC BOARD ..................................................................3
SCHEMATIC DIAGRAM ............................................11
EXPLODED VIEW .....................................................19
PARTS LIST...............................................................20
SECIFICATIONS........................................................28
CAUTIONS
