VRS-7100
2
CONTENTS / ACCESSORIES / CAUTIONS
Speaker cord connectors (1)
For Europe and Australia only
(E69-0013-05)
Remote control unit (1)
For Europe
RC-R0730E(A70-1653-05)
For the U.S.A., Canada and Australia
RC-R0730(A70-1652-05)
Batteries (R6/AA) (2)
AM loop antenna (1)
(T90-0906-05)
FM indoor antenna (1)
For Europe and Australia
(T90-0877-05)
For the U.S.A. and Canada
(T90-0905-05)
ACCESSORIES
CONTENTS
CONTENTS / ACCESSORIES / CAUTIONS ...............2
PC BOARD ..................................................................3
SCHEMATIC DIAGRAM ............................................15
EXPLODED VIEW .....................................................28
PARTS LIST...............................................................29
SECIFICATIONS........................................................35
Unplug the power cord from the wall outlet, then plug it
back in while holding down the POWER ON/STANDBY
(For U.S.A and Canada) or ON/STANDBY
key (For
Europe and Australia).
Please note that resetting the microcomputer will clear the
contents of the memory and returns the unit to the state it
was in when it left the factory.Memory back-up function
Resetting the Microcomputer
The microcomputer may malfunction (unit cannot be operated, or
shows an erroneous display) if the power cord is unplugged
while the power is ON, or due to some other external factor. If
this happens, execute the following procedure to reset the micro-
computer and return the unit to its normal operating condition.
Memory back-up function
If the power supply to the receiver is shut down for about a day
or more, the following settings will be reset to the initial
conditions. Please be careful.
Power mode = OFF
Volume level = - 66 dB
Dimmer level = OFF (Brightest condition)
Broadcast band = FM
Frequency setting = 87.50 MHz
Tuning mode = AUTO
CAUTIONS
