Memory back-up function
If the power supply to the receiver is shut down for about a day
or more, the following settings will be reset to the initial condi-
tions. Please be careful.
Power mode = OFF
Volume level = - 66 dB
Dimmer level = OFF (Brightest condition)
Broadcast band = FM
Frequency setting = 87.50 MHz
Tuning mode = AUTO
Soft reset:
This reset procedure allows the setups made by the user to be held
without being reset.
(For U.S.A and Canada)
Press POWER ON/STANDBY key to turn this unit OFF (STANDBY),
and then press POWER ON/STANDBY key again to turn it ON.
If a memory card is inserted, remove the memory card after pressing
POWER ON/STANDBY
key to turn this unit OFF (STANDBY). After
removal, press POWER ON/STANDBY
key again to turn it on.
(For Europe and Australia)
Press ON/STANDBY
key to turn this unit OFF (STANDBY), and
then press ON/STANDBY
key again to turn it ON.
If a memory card is inserted, remove the memory card after pressing
ON/STANDBY
key to turn this unit OFF (STANDBY). After removal,
press ON/STANDBY
key again to turn it on.
Reset to the factory default setups:
Unplug the power cord from the wall outlet, then plug it back in
while holding down the POWER ON/STANDBY
(For U.S.A
and Canada) or ON/STANDBY
key (For Europe and Australia).
Please note that resetting the microcomputer will clear the contents
of the memory and returns the unit to the state it was in when it left
the factory.
Remote control unit (1)
For Europe
RC-R0826E(A70-1651-05)
For the U.S.A., Canada and Australia
RC-R0826(A70-1650-05)
AM loop antenna (1)
(T90-0906-05)
FM indoor antenna (1)
For Europe and Australia
(T90-0175-05)
For the U.S.A. and Canada
(T90-0905-05)
FM antenna adaptor (1)
For Europe and Australia
(T90-0827-05)
CD-ROM (PC application) (1)
(W01-1835-05)
Batteries (R6/AA) (2)
Speaker cord connectors (1)
(E69-0013-05)
VRS-N8100
2
ACCESSORIES / CAUTIONS
ACCESSORIES
CAUTIONS
Note for Servicing of the PC Control Unit (X17-1100-11)
Each unit of VRS-N8100 has its own MAC (Media Access Control) address.
The MAC address is written in IC202 of the PC Control Unit. This means that replacing the PC Control Unit or IC202 results in
changing the MAC address of the unit. Therefore, when the PC Control Unit or IC202 is replaced, the user should be informed of
the new MAC address. Also, the new MAC address should be recorded and maintained in the servicing record together with the
serial number of the unit.
The MAC address can be confirmed in item "IP" setting in the Setup Menu (Network Setup).
Frequently Asked Questions (FAQ):
If you still have questions concerning the product after reading this manual, please consult the FAQ section on the KEN-
WOOD website of your resident country (if necessary you can find a link to your local website on www.kenwood.com
<http://www.kenwood.com>).
Software and Firmware update:
The latest information and procedure to update your KENWOOD PC SERVER software and VRS-N8100 Firmware can be
found in the "Technical Support" / "Service" section on the website of your resident country (if necessary you can find a link to
your local website on www.kenwood.com <http://www.kenwood.com>).
The above-mentioned information is opened to the public.
