2
KRP-S01
1
2
3
4
C
D
F
A
B
E
1
2
3
4
1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
Network ASSY
When reassembling it,
apply a adhesive to the screws.
1
2
1
Input terminal
1.1 GRILLE ASSY
1
2
3
4
5
6
7
8
11
12
9
10
13
Grille ASSY
Grille ASSY
OK
NG
1.2 WOOFER
1.3 TWEETER
Disassembly
Reassembly
Baffle Assy(Caution)
Network Assy(Caution)
Reassembly
Reassembly
Disassembly
Disassembly
The Grille Assy is secured to the baffle plate with adhesive double
side coated tape and bosses. When removing the Grille Assy, it is
necessary to wear cotton gloves.
Remove it from the under side.
1. Insert the tip of your gloved finger into the gap between the
Grille Assy in front and the corner of the baffle plate so that the
Grille Assy is slightly lifted.
2. Insert the gloved finger to the extent of the second joint into the
gap between the cabinet and the Grille Assy.
3. Alternately and gradually lift the left and right sides of the
Grille Assy by about 5 cm, sliding gloved fingers along the
cabinet. When lifting the Grille Assy, be sure to lift the left and
right side alternately, but not both sides simultaneously.
Note: Be careful not to bend the Grille Assy too far. Otherwise, it
may be damaged.
OK : Good example NG : Bad example
Remove the old adhesive double side coated tape attached
between the rear side of the Grille Assy and the front side of the
Baffle, and then attach new one. Press the bosses into the baffle
plate and press the entire grille into position.
The woofer is attached to the baffle plate by internal four screws.
To remove the woofer, first remove the baffle plate.
When reassembling the woofer, face its plus terminal downward.
Tighten the screws to the baffle.
The tweeter is attached to the baffle plate by internal two screws.
To remove the tweeter, first remove the baffle plate.
When reassembling the tweeter, face its plus terminal outside.
When removing the Network Assy, pull it out a little at a time
from alternate sides, because it is seated tightly.
When reassembling the cabinet and the baffle plate, secure the
screws in the order shown in the figure below:
