2
1
23
4
12
3
4
C
D
F
A
B
E
PDP-S39
FOR PRECAUTION OF REASSEMBLY AND DISASSEMBLY
The grille is attached to the baffle using double-sided self-adhe-
sive tape. To avoid damaging the cabinet, work with the
speaker on top of a blanket or similar, face the grille upward.
There are 2 slots in the lower part of the speaker. Insert a screw-
driver(-) into slot and push up detach the lower part.
Taking care not to damage the grille and baffle, lift the grille a
little bit at a time with hand.
When reattaching the grille, use double-sided self-adhesive
tape in the locations shown in the diagram and press the grille
assy into place.
The grille is fixed using boss and double-sided self-adhesive
tape (The tape is in the locations indicated in the diagram be-
low). Do not use a dryer to heat the self-adhesive tape when
removing the grille.
The woofer is attached to the baffle by 4 internal screws. To
detach it, first remove the baffle from cabinet. Then unfasten
those screws. When attaching the woofer, face its plus terminal
inner side of the baffle.
The tweeter is attached to the baffle by 2 internal screws. To
detach it, first remove the baffle from cabinet. Then unfasten
those screws. When attaching it, face its plus terminal right-
ward.
GRILLE
Screwdriver(-)
Grille
Cabinet
Slot
LOCATIONS TO FIX DOUBLE-SIDED SELF-ADHESIVE TAPE AND GASKET
Grille ASSY
(Back Side, symmetrical appearance)
(23)
Tape
(SEH1082)
(33)
Gasket
(SEC2022)
Gasket
(SEC1988)
Gasket
(SEC1988, SEC2022)
Do not stick out from edge