PDP-S61
2
12
3
4
12
3
4
C
D
F
A
B
E
1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
1.1 GRILLE ASSY
The Grille Assy is secured to the baffle plate with two-sided tape
and bosses. When removing the Grille Assy, if is necessary to wear
cotton gloves.
Disassembly
Remove it from the under side.
1. Insert the tip of your gloved finger into the gap between the
Grille Assy in front and the corner of the baffle plate so that the
Grille Assy is slightly lifted.
2. Insert the gloved finger to the extent of the second joint into the
gap between the cabinet and the Grille Assy.
3. Alternately and gradually lift the left and right sides of the Grille
Assy by about 5 cm, sliding gloved fingers along the cabinet. When
lifting the Grille Assy, be sure to lift the left and right sides alter-
nately, but not both sides simultaneously.
Note: Be careful not to bend the Grille Assy too far. Otherwise, it
may be damaged.
OK : Good example NG : Bad example
Reasassembly
Remove the old two-sided tape attached to the rear side of the Grille
Assy and the front side of the Baffle, and adhere new two-sided
tape. Press the bosses into the baffle plate and press the entire grille
into position. (Press the bosses from the woofer frame.)
1.2 WOOFER (Disassembly)
The woofer is secured to the baffle plate with four screws from the
outside. To remove the woofer, first remove the baffle plate. (Re-
move the baffle plate first, because the cables from the Network
Assy are short.) Remove the two packings from the side of the
woofer frame.
Reasassembly
When reassembling the woofer, place it so that its connector plate
is facing downward. Tighten the screws to the baffle, then attach
the two packings to the side of the woofer frame.
1.3 TWEETER (Disassembly)
The tweeter is secured to the baffle plate with three screws from
the outside. To remove the tweeter, first remove the baffle plate.
(Remove the baffle plate first, because the cables from the Net-
work Assy are short.)
Reasassembly
When reassembling the tweeter, place it so that its connector and
screw-hole positions align with those on the baffle plate.
Network Assy (Caution)
· When removing the Network Assy, pull it out a little at a time
from alternate sides, because it is seated tightly.
Baffle Assy (Caution)
· When reassembling the cabinet and the baffle plate, secure the
screws in the order shown in the figure below:
Grille ASSY
Grille ASSY
OK
NG
Network ASSY
When reassembling it,
apply a adhesive to the screws.
1
2
1
Input terminal
5
6
7
8
9
4
3
2
1
