2
PDP-S63
1
2
3
4
C
D
F
A
B
E
1
2
3
4
1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
Network ASSY
1
2
1
Input terminal
1.1 GRILLE ASSY
Baffle
5
6
4
3
2
1
Grille ASSY
Baffle
Grille ASSY
Baffle
OK
NG
1.2 WOOFER(Disassembly)
1.3 TWEETER(Disassembly)
Disassembly
Reasassembly
Baffle Assy(Caution)
Network Assy(Caution)
Reasassembly
Reasassembly
The Grille Assy is secured to the baffle plate with two-sided tape
and bosses. When removing the Grille Assy, it is necessary to
wear cotton gloves.
1. Insert the tip of your gloved finger into the gap between the
Grille Assy in front and the corner of the baffle plate so that the
Grille Assy is slightly lifted.
2. Insert the gloved finger to the extent of the second joint into the
gap between the cabinet and the Grille Assy.
3. Alternately and gradually lift the left and right sides of the Grill
Assy by about 5 cm, sliding gloved fingers along the cabinet.
When lifting the Grille Assy, be sure to lift the left and right sides
alternately, but not both sides simultaneously.
Note: Be careful not to bend the Grill Assy too far. Otherwise, it
may be damaged.
OK : Good example NG : Bad example
Remove the old two-sided tape attached to the rear side of the
Grille Assy and the front side of the Baffle, and adhere new two-
sided tape. Press the bosses into the baffle plate and press the
entire grille into position.
The woofer is secured to the baffle plate with four screws from the
inside. To remove the woofer, first remove the baffle plate.
When reassembling the woofer, place it so that its + terminal is
suitable for the inside. Tighten the screws to the baffle.
The tweeter is secured to the baffle plate with two screws from the
inside. To remove the tweeter, first remove the baffle plate.
When reassembling the tweeter, + terminal faces it aloft.
When removing the Network Assy, pull it out a little at a time
from alternate sides, because it is seated tightly.
When reassembling the cabinet L , R and the baffle plate, secure
the screws in the order shown in the figure below:
