2
PDP-S64
1
2
3
4
C
D
F
A
B
E
1
2
3
4
1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
Network ASSY
When reassembling it,
apply a adhesive to the screws.
1
2
1
Input terminal
1.1 GRILLE ASSY
1
2
3
4
5
6
7
8
11
12
9
10
13
Grille ASSY
Grille ASSY
OK
NG
1.2 WOOFER(Disassembly)
1.3 TWEETER(Disassembly)
Disassembly
Reasassembly
Baffle Assy(Caution)
Network Assy(Caution)
Reasassembly
Reasassembly
The Grille Assy is secured to the baffle plate with two-sided tape
and bosses. When removing the Grille Assy, if is necessary to
wear cotton gloves.
Remove it from the under side.
1. Insert the tip of your gloved finger into the gap between
theGrille Assy in front and the corner of the baffle plate so that the
Grille Assy is slightly lifted.
2. Insert the gloved finger to the extent of the second joint into the
gap between the cabinet and the Grille Assy.
3. Alternately and gradually lift the left and right sides of the
Grille Assy by about 5 cm, sliding gloved fingers along the
cabinet. When lifting the Grille Assy, be sure to lift the left and
right sides alternately, but not both sides simultaneously.
Note: Be careful not to bend the Grille Assy too far. Otherwise, it
may be damaged.
OK : Good example NG : Bad example
Remove the old two-sided tape attached to the rear side of the
Grille Assy and the front side of the Baffle, and adhere new two-
sided
The woofer is secured to the baffle plate with four screws from the
inside. To remove the woofer, first remove the baffle plate.
When reassembling the woofer, place it so that its + terminalis is
facing downward. Tighten the screws to the baffle.
The tweeter is secured to the baffle plate with two screws from the
inside. To remove the tweeter, first remove the baffle plate.
When reassembling the tweeter + terminal fces outside.
When removing the Network Assy, pull it out a little at a time
from alternate sides, because it is seated tightly.
When reassembling the cabinet and the baffle plate, secure the
screws in the order shown in the figure below:
tape. Press the bosses into the baffle plate and press the entire
grille into position.
