2
SD-T500W
CONTRAST OF SD-T500W/SAM AND SD-T50W1/SL
SD-T500W/SAM and SD-T50W1/SL have the same construction except for the following:
Ref.No.
Mark
Symbol and Descriotion
Part No.
SD-T50W1/SL
SD-T500W/SAM
P5-2
VIDEO · UCOM ASSY
AWV1542
AWV1666
P5-45
AC POWER CORD
ADG1107
Not used
P5-46
AC POWER CORD
ADG1109
ADG7017
P5-70
REAR PANEL
ANC2276
ANC2306
P6-143
CONTROL SHEET
AAK2668
AAK2710
P6-144
INDICATOR PANEL
AAK2669
AAK2712
P6-152
OPERATING INSTRUCTIONS (English)
ARB1500
ARB1514
P6-152
OPERATING INSTRUCTIONS (Chinese)
Not used
ARC1497
P6-156
NSP
WARRANTY CARD
ARW1020
ARY1091
P7-165
UPPER CARTON
AHD2846
AHD2954
P7-166
UNDER CARTON
AHD2866
AHD2953
Remarks
VIDEO · UCOM ASSY
AWV1666 and AWV1542 have the same construction except for following:
Mark
Symbol and Description
Part No.
AWV1542
AWV1666
Remarks
IC3301
PD5423A
PD5468A
PD5372
PD5423A
Note : The number in the remarks column correspond to the number on the "EXPLODED VIEWS" .
1. CONTRAST OF MISCELLANEOUS PARTS
NOTES:
·Parts marked by "NSP" are generally unavailable because they are not in our Master Spare Parts List.
·The mark found on some component parts indicates the importance of the safety factor of the part.
Therefore, when replacing, be sure to use parts of identical designation.
·When ordering resistors, first convert resistance values into code form as shown in the following examples.
Ex.1 When there are 2 effective digits (any digit apart from 0), such as 560 ohm and 47k ohm (tolerance is shown by J=5%,
and K=10%).
560
56
× 101
561 ........................................................ RD1/4PU 5 6 1 J
47k
47
× 103
473 ........................................................ RD1/4PU 4 7 3 J
0.5
R50 ..................................................................................... RN2H R 5 0 K
1
1R0 ..................................................................................... RS1P 1 R 0 K
Ex.2 When there are 3 effective digits (such as in high precision metal film resistors).
5.62k
562
× 101
5621 ...................................................... RN1/4PC 5 6 2 1 F
·Parts marked by are important parts which relate in X-rays radiation.
If any of these parts need to be replaced, always replace with specified parts.
·Parts marked by × are important parts which relate in X-rays radiation. If a failure occurs in any of these parts, replace the
printed circuit board assembly where the relevant part has already been adjusted as a working component. Do not replace the
actual part itself. If any part marked by
× is replaced, there is danger of being exposed to X-rays.
