2
S-DV270T
1
2
3
4
C
D
F
A
B
E
1
2
3
4
1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
1.1 FRONT SPEAKER
GRILLE
The grille is attached to the cabinet by its bosses applied with
adhesive. To detach it, pry it open by inserting a flat blade
screwdriver into lower right and lower left slot. To attach it, apply
adhesive to the holes on the baffle. Then press it to the baffle.
CAUTION
There are 10 bosses for press-fitting at the grille. To detach the
grille, remove in order from lower bosses. (Refer to the figure
in page 4.) In order not to damage the bosses, don't remove it
forcibly. Pry it open little by little. Be sure to insert a flat blade
screwdriver from just beside of its bosses.
WOOFER
The woofer is attached to the baffle by 4 external screws. To
detach it, unfasten those screws. To detach it, first remove the
grille. Then remove the screws. When attaching it, face its
terminal downward.
TWEETER
The tweeter is attached to the baffle by 3 external screws. To
detach it, unfasten those screws. To detach it, first remove the
grille. Then remove the screws. When attaching it, face its
terminal leftward and rightward.
COSMETIC PANEL
The cosmetic panel is attached to the baffle by its bosses applied
with adhesive. To detach it, pry it open by inserting a flat blade
screwdriver into lower slot. To detach it, first remove the speaker
stand base and grille. Then remove the cosmetic panel. When
attaching it, fit the boss into the hole on the baffle.
SPEAKER STAND BASES
The speaker stand base is attached to the bottom of cabinet by 3
external screws. To detach it, unfasten those screws. Attach the
speaker stand bases to the stems using the screws provided. Once
you have aligned the stem and base, secure with the small screws
at the points shown below. Note that the speaker should face in
the direction of the base of the isosceles triangle (outlined below).
1.2 CENTER SPEAKER
GRILLE
The grille is attached to the cabinet by 8 external screws. To
detach it, unfasten those screws.
SPEAKER UNIT
The speaker unit, together with the grille, is attached to the
cabinet by 4 external screws. To detach it, first unfasten those
screws. Next remove the cabinet. Then remove the cable. When
re-attaching it, face its terminal toward the leftward.
1.3 SURROUND SPEAKER
GRILLE
The grille is attached to the cabinet by 6 external screws. To
detach it, unfasten those screws.
SPEAKER UNIT
The speaker unit, together with the grille, is attached to the
cabinet by 4 external screws. To detach it, first unfasten those
screws. Next remove the cabinet. Then remove the cable. When
re-attaching it, face its terminal downward.
Speaker Stand Base
Stem
(the bottom of cabinet)
Front
Rear
