ORDER NO.
PIONEER CORPORATION 4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan
PIONEER ELECTRONICS (USA) INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A.
PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium
PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER CORPORATION 2005
RRV3179
T ZZK JUNE 2005 Printed in Japan
SPEAKER SYSTEM
S-EV1000V
XJM/E
S-EV1000V XJM/NC
Center
Surround
Sub Woofer
Front
FOR PRECAUTION OF
REASSEMBLY AND DISASSEMBLY
CS Assy ( Front )
The grille assy is attached to the cabinet by catches. Detach by
pulling it toward you.
The catch is attached to the cosmetic baffle by press-fitting. To
detach it, insert a sharp-pointed tool like an eyeleteer into each
of side. To attach it, insert the holes of the cosmetic baffle assy
by press-fitting.
The cosmetic baffle assy is attached to the inner baffle by its
bosses. To detach it, pry it open by inserting a flat blade screw
driver into lower slot. To attach it, clean the press-fitting part
and apply a bit of adhesive . Then press it to the bafle. (Fig. 1)
The tweeter is attached to the cosmetic baffle by 2 internal
screws. To detach it, first remove the cosmetic baffle and the
connecting cord to a tweeter. Then unfasten those screws.
When attaching it, face its terminal downward.
The woofer is attached to the inner baffle by 4 screws with the
screw heads facing the cosmetic baffle. To detach it, first re-
move the cosmetic baffle and the connecting cord to a tweeter.
Then unfasten those screws. To attach it, replace the connecting
cord to a tweeter correctly and face its terminal downward. If
the connecting cord with packing overflows a slot, it will be-
come the cause of air-leak and unusual sound.
The passive radiator is attached to the inner baffle by 4 screws
with the screw heads facing the cosmetic baffle. To detach it,
first remove the cosmetic baffle and the connecting cord to a
tweeter. Then unfasten those screws.
The input terminal is attached to the back board by press-fitting
and glue. To detach it, pry it open by inserting a flat blade
screwdriver into the lower side. When attaching it, the red ter-
minal is right-side.
Fig. 1
apply adhesive
apply adhesive