FOR PRECAUTION OF
REASSEMBLY AND DISASSEMBLY
The grille is attached to the cabinet by catches. Detach by pull-
ing it toward you.
The woofer is attached to the cosmetic baffle by 4 internal
screws. The cosmetic baffle is atached to the cabinet by 4 exter-
nal screws. To detach it, first insert a sharp-pointed tool like an
eyeleteer into the catch and push up. Next unfasten screws for
the cosmetic baffle. Then unfasten those screws.
When attaching the woofer, face its terminal downward. When
attaching the cosmetic baffle on the cabinet by screws.
The tweeter is attached to the cosmetic baffle by 2 internal
screws. The cosmetic baffle is atached to the cabinet by 4 exter-
nal screws and 2 bosses. To detach it, perform same as the
woofer.
(Front SP)
(Sub Woofer)
The woofer is attached to the back board by 4 external screws.
To detach it, unfasten those screws.
The input terminal is attached to the back board of the cabinet
together with the adhesive by press-fitting. To detach the input
terminal, pry it open by inserting a flat blade screwdriver into
the upper and lower slot of the input terminal. To attach the
input terminal, replace it on the back board of the cabinet cor-
rectly together with the adhesive by press-fitting. (The red ter-
minal is right-side.)
The cosmetic baffle is attached to the baffle of the cabinet to-
gether with the adhesive by press-fitting. To detach the cos-
metic baffle, pry it open by inserting a flat blade screwdriver
into the lower slot of it. To attach the cosmetic baffle, replace it
on the baffle of the cabinet together with the adhesive by press-
fitting.
How to replace the cosmetic baffle and cosmetic duct
1. Remove the speaker from the cabinet, first removing the four
screws.
2. Reach through the hole where the speaker was originally lo-
cated and pull out the damper attached at the end of the cos-
metic duct by hand. (Damper: See Product Appearance 11.)
Note: Detach the damper with great care so as not to damage
the interior surface of its circumference.
3. With the aid of a flathead screwdriver inserted through the slit
at the lower part of the cosmetic baffle, remove the cosmetic
baffle from the cabinet.
4. Reassemble the subwoofer, as shown below:
4-1 Apply adhesive to the cosmetic baffle and press it into the
cabinet.
4-2 Apply adhesive to the interior surface of the circumfer-
ence of the damper previously removed.
4-3 Insert the damper into the cabinet through the hole where
the speaker was, and adhere it so that the end of the cos-
metic duct is on the same plane as the surface of the
damper.
4-4 Secure the speaker to the cabinet with the four screws pre-
viously removed.
