ORDER NO.
PIONEER CORPORATION 4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan
PIONEER ELECTRONICS SERVICE, INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A.
PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium
PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER CORPORATION 2000
RRV2359
T-ZZM JULY 2000 Printed in Japan
S-HS77-F
XMA/NC
S-HS77-CR XMA/NC
SPEAKER SYSTEM
FOR PRECAUTION OF
REASSEMBLY AND DISASSEMBLY
The grille is attached to the cabinet by catches.
Detach by pulling it toward you.
The woofer is attached to the baffle by 4 external screws.
To detach it, unfasten those screws.
When attaching it, face its terminal downward.
The midrange is attached to the flange lower side by 4 external
screws. To detach it, unfasten those screws. When attaching it,
face its terminal downward.
The tweeter is attached to the flange upper side by 2 external
screws. To detach it, unfasten those screws. When attaching it,
first reattach the packing around tweeter diaphragm, then face
its terminal downward.
The flange is attached to the baffle by 4 external screws. To
detach it, unfasten those screws. When attaching it, face it
downward.
To detach the midrange or tweeter, first remove the flange.
Then remove it.
The input terminal is attached to the back board by press-fitting
and applied with adhesive. To detach it, pry it open by inserting
a flat blade screwdriver into lower side.
The Network Assy is attached to the input terminal by
soldaring.
[ Front speaker ]
[ Center speaker ]
The grille is attached to the cabinet by catches.
Detach by pulling it toward you.
The woofer is attached to the baffle by 4 external screws.
To detach it, unfasten those screws.
When attaching it, first exchange the flange, then face its termi-
nal downward.
The tweeter is attached to the baffle by 4 external screws.
The cosmetic packing is attached to the flange applied with
adhesive.To detach the tweeter. First remove the cosmetic
packing, then unfasten those screws. When attach it, do so that
it will move vertical. The tweeter wires, connected in the
middle of network Assy , are covered with the insulating tape.
The input terminal is attached to the back board by press-fit-
ting. To detach it, pry it open by inserting a flat blade screw-
driver into lower side.
The Network Assy is attached to the input terminal by
soldaring.
[ Rear speaker ]
When exchange the rear speaker, do it with the CS Assy (R).
Front
Center
Rear
