ORDER NO.
PIONEER CORPORATION 4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan
PIONEER ELECTRONICS SERVICE, INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A.
PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium
PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER CORPORATION 2001
c
S-L11-Q-LRW
RRV2484
T ZZV JUNE 2001 Printed in Japan
SPEAKER SYSTEM
XJI/EW
65S
This service manual is intended for qualified service technicians; it is not meant
for the casual do-it-yourselfer. Qualified technicians have the necessary test
equipment and tools, and have been trained to properly and safely repair complex
products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability
of the product and may void the warranty. If you are not qualified to perform the
repair of this product properly and safely, you should not risk trying to do so and
refer the repair to a qualified service technician.
WARNING
This product contains lead in solder and certain electrical parts contain chemicals
which are known to the state of California to cause cancer, birth defects or other
reproductive harm.
Health & Safety Code Section 25249.6 Proposition 65
This product is component of system.
Component
System
Service Manual
Remarks
COMPACT MINI COMPONENT
SEREO CD TUNER
XC-L11
RRV2470
STEREO POWER AMPLIFIER
M-L11
RRV2479
SPEAKER SYSTEM
S-L11-Q-LRW
RRV2484
This service manual
FOR PRECAUTION OF
REASSEMBLY AND DISASSEMBLY
The grille is attached to the cabinet by 4 external screws.
To detatch it ,unfasten those screws.
(Satellite)
The cosmetic baffle is attached to the baffle by press-fitting.
To detatch it , pry it open by inserting a flat blade screwdriver
into lower side.
To attach the cosmetic baffle, replace it on the backboard cor-
rectly by press-fitting.
The input terminal is attached to the backboard by press-fitting.
To detatch it , pry it open by inserting a flat blade screwdriver
into lower side.
To attach the input terminal, replace it on the backboard cor-
rectly by press-fitting. (The red terminal is right side.)
The woofer is attatched to the backboard by 4 external screws.
To detach it, unfasten those screws. When attatching it, face its
terminal downward.
(Subwoofer)
The speaker element is attatched to the baffle by 4 internal
screws. To detach it, first remove the cabinet . Then remove the
speaker element by unfastening those screws. When attatching
it, face its terminal upward.
SATELLITE
SUBWOOFER
