ORDER NO.
PIONEER ELECTRONIC CORPORATION 4-1, Meguro 1-Chome, Meguro-ku, Tokyo 153-8654, Japan
PIONEER ELECTRONICS SERVICE, INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A.
PIONEER ELECTRONIC (EUROPE) N.V. Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium
PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 501 Orchard Road, #10-00 Lane Crawford Place, Singapore 0923
PIONEER ELECTRONIC CORPORATION 1998
RRV1959
T-ZZW APR. 1998 Printed in Japan
FOR PRECAUTION OF
REASSEMBLY AND DISASSEMBLY
This product is component of system.
For the operating instructions, refer to the service manual RRV1946 for XC-L7.
S-L7-R-LRW/XC consists of Sub Woofer(1pc) and Satellite Speaker(S-L7-R-LR/XC 2pcs).
SPEAKER SYSTEM
S-L7-R-LRW
XC
65S
This service manual is intended for qualified service technicians; it is not meant for the
casual do-it-yourselfer. Qualified technicians have the necessary test equipment and
tools, and have been trained to properly and safely repair complex products such as
those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability
of the product and may void the warranty. If you are not qualified to perform the repair
of this product properly and safely, you should not risk trying to do so and refer the
repair to a qualified service technician.
WARNING
Lead in solder in this product is listed by the California Health and Welfare agency as
a known reproductive toxicant which may cause birth defects or other reproductive
harm (California Health & Safety Code, Section 25249.5).
When servicing or handling circuit boards and other components which contain lead in
solder, avoid unprotected skin contact with the solder. Also, when soldering do not in
hale any inhale any smoke or fumes produced.
[ Sub Woofer ]
The speaker element, together with the flange, is attached to
the back board by 4 external screws. To detach it, unfasten
those screws. When attaching it, face its terminal upward.
The duct is attached to the baffle by press-fitting. To detach it,
pry it open by inserting a flat blade screwdriver into lower side.
The input terminal is attached to the back board by press-fit-
ting. To detach it, pry it open by inserting a flat blade screw-
driver into lower side.
[ Satellite Speaker ] (S-L7-R-LR)
The grille is attached to the cabinet by 4 external screws.
To detach it, unfasten those screws.
The speaker element, together with the grille is attached to the
cabinet by 2 external screws. To detach it, unfasten those
screws. When attaching it, face its terminal upper left.
The cabinet is attached to the baffle by 4 external screws.
To detach it, first remove the grille. Then remove the cabinet.
The input terminal is attached to the cabinet by 2 internal
screws. To detach it, first remove the grille and the baffle.
Then remove the input terminal.
The bushing is attached to the cabinet by press-fitting.
To detach it, first remove the grille. Then remove the bushing.
