ORDER NO.
PIONEER CORPORATION 4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan
PIONEER ELECTRONICS (USA) INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A.
PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium
PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER CORPORATION 2007
Front/Center
Surround
SSP-LX70ST
RRV3685
SPEAKER SYSTEM
SSP-LX70ST
XTW/E
1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
1.1 FRONT/CENTER SPEAKER
1.2 SURROUND SPEAKER
The grille is attached to the cabinet by press-fitting. To detach it,
first pry cosmetic top panel open by inserting a flat blacle
screwdriver into upside of back board. When you remove the grille
on the front and the side, first of all, remove the cosmetic top panel.
Next, pry it open by inserting a flat blade screwdriver between each
cosmetic panel and the cabinet. Then detach by pulling the grille
toward you. When attaching it, press-fit it carefully it the direction
of the grille. Match the direction of the arrow marked on the back
side of the grille frame and the direction of the speaker terminal.
The two front speaker units are attached front to the cabinet by
4 external screws. To detach it, first remove the grille. Next
unfasten the screws. Then remove the cable. When attaching it, face
its terminal toward the input terminal. The center spaker unit is
attached to the cabinet by 4 external screws. To detach it, first
remover the grille, Next unfasten those screws. Then remove the
cable. When attaching it, face its terminal toward the cutting lack of
installation hole.
The grille is attached to the cabinet by press-fitting. To detach it,
first pry cosmetic top panel open by inserting a flat blacle
screwdriver into upside of back board. When you remove the grille
on the front and the side, first of all, remove the cosmetic top panel.
Next, pry it open by inserting a flat blade screwdriver between each
cosmetic panel and the cabinet. Then detach by pulling the grille
toward you. When attaching it, press-fit it carefully it the direction
of the grille. Match the direction of the arrow marked on the back
side of the grille frame and the direction of the speaker terminal.
The two surround speaker units are attached remove the grille to
the cabinet by 4 external screws. To detach it, first remove the
grille. Next then remove the cable. When attaching it, face its
terminal toward the input terminal.
The cosmetic panels of each unit are attached to the cabinet by
press-fitting. When reattach the product which is loose press fit,
apply adhesive (GYA1011 [silicon adhesive: KE-40RTV]) to the
four boss installation holes of the cabinet.
1.3 COSMETIC PANEL
T-ZZR NOV. 2007 Printed in Japan
