ORDER NO.
PIONEER CORPORATION 4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan
PIONEER ELECTRONICS (USA) INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A.
PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium
PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER CORPORATION 2003
RRV2762
T ZZM APR. 2003 Printed in Japan
S-PR7-S-LR
FOR PRECAUTION OF
REASSEMBLY AND DISASSEMBLY
65S
This service manual is intended for qualified service technicians; it is not meant
for the casual do-it-yourselfer. Qualified technicians have the necessary test
equipment and tools, and have been trained to properly and safely repair complex
products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability
of the product and may void the warranty. If you are not qualified to perform the
repair of this product properly and safely, you should not risk trying to do so and
refer the repair to a qualified service technician.
WARNING
This product contains lead in solder and certain electrical parts contain chemicals
which are known to the state of California to cause cancer, birth defects or other
reproductive harm.
Health & Safety Code Section 25249.6 Proposition 65
The grille is attached to the cabinet by catches. Detach by pull-
ing it toward you.
The woofer is attached to the inner baffle by 4 external screws.
To detach it, first remove the cosmetic baffle assy. Then unfas-
ten those screws. When attaching it, face its terminal upward.
The tweeter is attached to the inner baffle by external adhesive
double-coated tape. To detach it, first remove the cosmetic
baffle assy and the woofer. Then remove the tweeter together
with adhesive tape. When attaching it, first turn off the back
cover of adhesive double-coated tape and face its cord down-
ward. Next go it through the slit of the inner baffle. Then attach
the adhesive tape there not to project.
S-PR7-S-LR
SPEAKER SYSTEM
XCN/WL
The input terminal is attached to the back board applied with
adhesive by 4 screws. To detach it, unfasten those screws and
pry it open by inserting a flat blade screwdriver between the
back board and the input terminal. Then detach the connection
cord. To attach it, apply adhesive to the back board and face its
red terminal rightward. Then attach it by 4 screws.
