2
Inserting/replacing the battery
If the battery voltage is sufficient, the "batt" LED
» flashes briefly when you
switch on the microphone. A new, unused battery has an operating time of
approx. 300 hours.
When the battery voltage decreases, the "batt" LED
» lights up
permanently. You should replace the battery. When the "batt" LED
» lights
up permanently for the first time, the remaining operating time is approx. 50
hours.
Note:
When not using the microphone for extended periods of time,
remove the battery from the battery compartment!
To insert or replace the battery:
Push the catch of the battery compartment
¶ in
the direction of the flashmount adapter and open
the battery compartment.
Insert the AAA size battery as shown in the
diagram on the right. Observe correct polarity
when inserting the battery.
Close the battery compartment until the catch
¶
locks into place.
Puting the microphone into operation
Slide the microphone onto the video camera's flashmount and lock the
microphone by screwing down the knurled washer
².
Insert the 3.5 mm stereo jack plug into the microphone input socket of the
video camera.
MKE400_516599_0607_SP6.book Seite 2 Freitag, 2. November 2007 12:16 12
