1 SPECIFICATIONS
2
Amplifier Section
Output Power .... 50 + 50 watts RMS (0.9 % THD, 1 kHz, 8 ohms)
Total Harmonic Distortion.................... 0.05 % (at 45 watts,1 kHz)
Input Sensitivity/Impedance .................. PHONO: 4 mV/22 kohms
LINE: 270 mV/20 kohms
Frequency Response.................... PHONO: 20 Hz20 kHz, +/3 dB
LINE: 20 Hz30 kHz, +1/3 dB
Signal-to-Noise Ratio.............................................. PHONO: 60 dB
LINE: 68 dB
Tone Control .......................................... BASS: +/9 dB at 100 Hz
TREBLE: +/7 dB at 10 kHz
Loudness Control (Volume at 40 dB Position) ..............................
+7 dB at 100 Hz, +5 dB at 10 kHz
FM Tuner Section
(Without notes 98.1 MHz, 65 dBf)
Tuning Range .................... 87.5 MHz108.0 MHz (100 kHz steps)
Usable Sensitivity (IHF) ............................................ Mono: 20 dBf
50 dB Quieting Sensitivity ................ Mono: 39 dBf, Stereo: 46 dBf
Capture Ratio ...................................................................... 2.8 dB
Image Rejection Ratio .......................................................... 20 dB
AM Suppresion Ratio............................................................ 48 dB
Harmonic Distortion (1 kHz) .............. Mono: 0.4 %, Stereo: 0.5 %
Frequency Response................................ 30 Hz15 kHz, +2/3 dB
Stereo Separation (1 kHz) .................................................... 35 dB
Signal-to-Noise Ratio ........................ Mono: 57 dB, Stereo: 55 dB
AM Tuner Section
Tuning Range .......................... 520 kHz1,720 kHz (10 kHz steps)
Usable Sensitivity ............................................................ 55 dB/m
Total Harmonic Distortion .................................... 1 % at 85 dB/m
Signal-to-Noise Ratio............................................................ 48 dB
General
Power Requirements.................................. 120 V/230 V, 50-60 Hz
Power Consumption ............................................................ 120 W
AC Outlet .......................... Unswitched x 1, 100 W max (1 A max)
Dimensions (W x H x D) ........................ 17-1/8" x 5-1/8" x 12-5/8"
(435 x 130 x 320 mm)
Weight (net) .................................................. 15-7/16 lbs (7.0 kg)
Standard Accessories .................................. AM Loop Antenna x 1
FM "T" Type Antenna x 1
· Design and specifications are subject to change without notice.
Voltage Conversion
(General export models only)
Be sure to remove the power cord from the AC outlet before
repositioning the voltage converter switch.
1. Locate the voltage selector on the rear panel.
2. Using a flat-bladed screwdriver, set to the appropriate
230V or 120V position according to your area.
IN NORTH AMERICA USE ONLY ON 120 V SUPPLY.
