SR-L38MP3
4
3 ADJUSTMENTS AND CHECKS
Use a screwdriver with a plastic or ceramic grip for all adjustment.
3-1 TUNER SECTION
1. Set the function switch to the TUNER position.
3-1-1 FM adjustment
3. Connect the signal generator output through a 75 ohm dummy
4. Connect the oscilloscope to the PHONES JACK terminal.
6. Set the signal generator as listed in the alignment chart.
antenna to "ANT" on MAIN PCB.
2. Set the BAND switch to the FM position.
1. Set the function switch to the TUNER position.
3. Connect the test loop antenna across the output of the signal generator.
4. Connect the oscilloscope to the PHONES JACK terminal.
6. Set the signal generator as listed in the alignment chart.
3-1-2 AM adjustment
3-2 Adjustment and Test Points
MAIN PCB
TC2
L3
L4
A
M
A
N
T
C
O
IL
2. Set the BAND switch to the AM position.
L1
L2
L
5
R5
R6
5. Connect the digital multimeter to R5/R6 on MAIN PCB.
5. Connect the digital multimeter to R5/R6 on MAIN PCB.