RQT5414
4
AC IN~
DIGITAL
DIGITAL
OPTICAL
OUT
OUT
RE-MASTER
PROCESSING
L
R
ON OFF
CLASS 1
LASER PRODUCT
(Back of product)
DANGER
INVISIBLE LASER RADIATION WHEN OPEN.
AVOID DIRECT EXPOSURE TO BEAM.
ADVARSEL
USYNLIG LASERSTRÅLING VED ÅBNING, NÅR SIKKERHEDSAFBRYDERE
ER UDE AF FUNKTION. UNDGÅ UDSÆTTELSE FOR STRÅLING.
VARO!
AVATTAESSA JA SUOJALUKITUS OHITETTAESSA OLET ALTTIINA
NÄKYMÄTÖNTÄ LASERSÄTEILYLLE. ÄLÄ KATSO SÄTEESEEN.
VARNING
OSYNLIG LASERSTRÅLNING NÄR DENNA DEL ÄR ÖPPNAD OCH
SPÄRREN ÄR URKOPPLAD. BETRAKTA EJ STRÅLEN.
ADVARSEL
USYNLIG LASERSTRÅLING NÅR DEKSEL ÅPNES OG SIKKERHEDSLÅS
BRYTES. UNNGÅ EKSPONERING FOR STRÅLEN.
VORSICHT
UNSICHTBARE LASERSTRAHLUNG, WENN ABDECKUNG GEÖFFNET.
NICHT DEM STRAHL AUSSETZEN.
(Indersiden at apparatet)
(Tuotteen sisällä)
(Apparatens insida)
(Produktets innside)
(Im Inneren des Gerätes)
(Inside of product)
Suggestions for safety
Placement
Avoid placing the unit in areas of:
·direct sunlight
·high temperature
·high humidity
·excessive vibration
·uneven surfaces (Place the unit on a flat level surface.)
Such conditions might damage the cabinet and/or other component
parts and thereby shorten the unit's service life.
To protect the unit against sound distortion and accoustical effects,
please place the unit at least 15 cm away from wall surfaces etc.
Stacking
Never place heavy items on top of the unit or the AC mains lead.
Voltage
·It is very dangerous to use an AC power source of high voltage such
as for an air conditioner.
A fire might be caused by such a connection.
·A DC power source can not be used.
Be sure to check the power source carefully, especially if on a ship
or other place where DC is used.
AC mains lead protection
·Avoid cuts, scratches or poor connection of the AC mains lead, as
this may result in fire or electric shock.
Excessive bending, pulling or slicing of the AC mains lead should
also be avoided.
·Do not pull on the AC mains lead when you are disconnecting the
power, as this could cause an electric shock. Grasp the plug firmly
when you disconnect the AC mains lead.
·Never touch the plug with wet hands or a serious electric shock
could result.
Foreign materials
·Ensure that no foreign objects, such as needles, coins, screwdriv-
ers etc., accidentally fall into the unit.
Otherwise, a serious electric shock or malfunction could occur.
·Be extremely careful about spilling water or liquid on/into the unit,
as a fire or electric shock could occur.
(Disconnect the power plug and contact your dealer immediately if
this occurs.)
·Avoid spraying insecticides onto the unit as they contain flammable
gases which can be ignited.
·Insecticides, alcohol, paint thinner and similar chemicals shoud never
be used to clean the unit as they can cause flaking or cloudiness to
the cabinet finish.
Service
·Never attempt to repair, disassemble or reconstruct the unit if there
seems to be a problem.
A serious electric shock could result if you ignore this precautionary
measure.
·If a problem occurs during operation (the sound is interrupted, indi-
cators fail to light up, smoke is detected, etc.) contact your dealer or
Authorized Service Center immediately.
·Disconnect the AC mains lead if the unit will not be used for a long
time. Otherwise the operation life could be shortened.
Connector
Approx. 6 mm
appliance inlet
Insertion of connector
Even when the connector is per-
fectly inserted, depending on the
type of inlet used, the front part of
the connector may jut out as
shown in the drawing.
However there is no problem
using the unit.
CAUTION!
THIS PRODUCT UTILIZES A LASER.
USE OF CONTROLS OR ADJUSTMENTS OR PERFORM-
ANCE OF PROCEDURES OTHER THAN THOSE SPECI-
FIED HEREIN MAY RESULT IN HAZARDOUS RADIATION
EXPOSURE.
DO
NOT
OPEN
COVERS
AND
DO
NOT
REPAIR
YOURSELF.
REFER
SERVICING
TO
QUALIFIED
PERSONNEL.
CAUTION!
DO
NOT
INSTALL
OR
PLACE
THIS
UNIT
IN
A
BOOKCASE, BUILT IN CABINET OR IN ANOTHER
CONFINED
SPACE.
ENSURE
THE
UNIT
IS
WELL
VENTILATED. ENSURE THAT CURTAINS AND ANY
OTHER
MATERIALS
DO
NOT
OBSTRUCT
THE
VENTILATION TO PREVENT RISK OF ELECTRIC SHOCK
OR FIRE HAZARD DUE TO OVERHEATING.
